ViewSonic PJ452
10
Setting up
WARNING ►Place the projector in a stable position horizontally. A fall or a
turnover could cause an injury and/or damage to the projector. Then using a
damaged projector could result in a fire and/or an electric shock.
• Don’t place the projector on an unstable, slant or vibrant surface such as a wobbly
or inclined stand.
• Do not place the projector in the side/front/rear-up position, except care of the air
filter.
• For the projector installed bottom-up, use the accessory filter cover for bottom-up
use. And in the case of a ceiling installation or the like, contact your dealer before
installation.
► Place the projection in a cool place, and pay attention enough to ventilation. The
high temperature of the projector could cause a fire, a burn and/or malfunction to
the projector.
• Don’t stop up, block and cover the projector's vents.
• Keep a space of 30 cm or more between the sides and other objects such as walls.
• Don’t place the projector on a metallic thing or anything weak in heat.
• Don’t place the projector on a carpet, cushion or bedding.
• Don’t place the projector in direct sunlight or near a hot object such as heater.
• Put nothing about lens and vents of the projector. Put nothing on the projector.
• Put nothing that is sucked or sticks to the bottom of projector. This projector also
has intake vents on the bottom of the unit.
► Do not place the projector on a wet surface. Damping the projector or inserting
liquid in the projector could cause a fire, an electric shock and/or malfunction to
the projector.
• Don’t place the projector in a bathroom or the outdoors.
• Put nothing containing the liquid near the projector.
CAUTION ► Avoid a smoky, humid or dusty place. Placing the projector in
such place could cause a fire, an electric shock and/or malfunction to the projector.
• Don’t place the projector near a humidifier, a smoking space or a kitchen.
• Put nothing containing liquid near the projector.
► Adjust the direction of the projector to keep light from directly hitting the
projector's remote sensor.
Downloaded From projector-manual.com Viewsonic Manuals
To Next Page
Loading...
Need help?
General
