15 ViewSonic PJ510
Turning Off The Power
NOTE:
Turn the power on/off in right order. Please power on the projector before the connected devices.
Power off the projector after the connected devices.
1 Press the STANDBY/ON button of the projector or the
remote control.
The message “Power off?” will appear on the screen for
approximately 5 seconds.
2 Press the STANDBY/ON button again while “Power off?”
the message is visible.
The projector lamp will go off, and the POWER indicator
will begin blinking orange.
Then the POWER indicator will stop blinking and light to
solid orange when the lamp cooling is complete.
3 Switch the power switch to [O] (OFF).
Power switch (ON position)
The POWER indicator will go off.
4 Attach the lens cap.
STANDBY/ON button
POWER indicator
Power switch
STANDBY/ON button
To Next Page
Loading...
