ViewSonic PJ510 36
1 Turn off the projector, and unplug the power cord.
2 After making sure that the projector has cooled adequately, remove the
filter cover.
Hold the release buttons of the filter cover, while pulling it up.
3 Wipe the transparent area of the filter cover by using a swab or a soft cloth.
4 Remove the air filter.
Hold the release buttons of the air filter, while pulling it down.
5 Wipe the dust-detecting window by using a soft cloth.
6 Replace the air filter and filter cover.
ATTENTION
The transparent area of filter cover and the dust-detecting window should be cleaned for normal
operation of the optical dust detecting system. Please pay attention not to remain fiber or fragment
of cloth inside the duct.
(Rear side)
Dust-detecting window
(Bottom side)
Filter cover
Release buttons
Release buttons
Air filter
Filter cover
Transparent area
To Next Page
Loading...
