26
Setting
Projector Projection
Adjust the picture to match the orientation of the projector: upright or upside-down, in
front of or behind the screen. Invert or reverse the image accordingly.
Menu Setting
Allow you to enter the Menu Setting menu.
• Menu Position: Choose the menu location on the display screen.
• Menu Display Time: Duration of OSD menu display countly starts (at idle state by
second).
• OSD Transparency: Select to change the transparency level of the OSD
background.
Signal Type
Specify the source to the COMPUTER IN 1/COMPUTER IN 2 terminal that you wish
to project.
• Auto:Automatically detect the input signal type from COMPUTER IN 1 and
COMPUTER IN 2 terminals.
• RGB:For VGA signal
• YCbCr/YPbPr:For component signal
Blank Screen
Blank the screen temporarily, and select the screen color when this function is active.
Start up Screen
Allow you to enter the Start up Screen menu. Screen capture doesn’t support in 3D
pattern.
• Start up Screen: Select start up screen when the projector is powered on or when
no signal is input. "User" is the screen that you captured.
• Screen Capture: Capture the current projection screen as a start up screen.
• Screen Capture Delete: Delete the captured projection screen.
Message
Enable or disable the message box at the right bottom of the screen.
Auto Source
Automatically scan through all the input source.
Power Saving
If the input source is not detected and no operation is performed for a specific period
of time, projector will automatically turn off.
Green Mode
Enable this function when power consumption is under 1W.
• Active VGA out: selecting on outputs a VGA signal when the computer in 1 and
To Next Page
Loading...
