The projector can be connected to multiple devices at the same time. However, it
can only display one full screen at a time.
If you want the projector to automatically search for the input source, ensure the
function in the menu is .
The can also be manually selected by pressing one of the source
selection buttons on the remote control, or by cycling through the available input
sources.
To manually select the input source do the following:
Press , and a source selecon menu will appear.
Press unl your desired signal is selected and press .
Once detected, the selected source informaon will be displayed on the screen
for a few seconds.
If there are mulple devices connected to the projector, repeat steps 1-2 to
search for another source.
To Next Page
Loading...
