This section will provided a better understanding of your projector’s lamp.
When the projector is being used, the duration (in hours) of lamp usage is
automatically calculated by the built-in timer.
To obtain the lamp hour information:
Press to open the OSD Menu and go to:
Press and the page will appear:
Press to leave the menu.
To prolong lamp life, you can adjust the following settings in the OSD Menu.
Setting the projector in or mode reduces system
noise, power consumption, and extends the lamps operational life.
Provides full lamp brightness.
Reduces lamp power consumpon by 16% and lowers brightness,
and decreases fan noise.
Reduces lamp power consumpon by up to 30% depending on the
content's brightness level.
Reduces lamp power consumpon by 60% and lowers brightness to
extend the lamp life and decreases the fan noise.
To set the Lamp Mode, open the OSD Menu and go to:
and press / to select and press .
This allows the projector to turn off automatically after a set period of time once no
input source is detected.
Open the OSD Menu and go to:
and press
/
to disable or adjust the time.
To Next Page
Loading...
