ViewSonic TD2455 - DisplayPort MST Daisy Chain

17


connect up to four (4) monitors. If your graphics card is DP 1.2 compliant and
supports MST mode:
1. Connect one end of a DisplayPort cable to the DisplayPort Out port of your
computer. Then connect the other end of the cable to the DisplayPort In port of
the monitor.
2. 
monitor. Then connect the other end of the cable to the DisplayPort In port of
the second monitor.
3. Repeat Step 2 as needed with up to four (4) monitors.
Type-C
OutIn OutIn OutIn OutIn

• 
• DisplayPort 1.2 MST must be turned on in the Setup Menu in the OSD
Menu to do daisy chaining.
• 

DisplayPort
In
DisplayPort
Out