Setup
ViewSonic 23 VMP71
Network
When this device is connected to a network, the Network setup menu will display the IP
address for either wired network with DHCP or wireless network.
Wired
DHCP:
IP address for this device will be automatically assigned by the Network.
Manual:
Use to manually assign the IP Address, Subnet Mask, and Default Gateway
used by this device. Use number pad on the remote control to enter the
desired addresses.
Wireless
Available SSIDs will be shown. Input Authentic code to gain access.
Note:
Please select "Open System", "WEP-PSK 64bit/128bit", and
"WPA1/2-PSK-AES/TKIP" authentication when setting up your wireless AP.
Network Sharing
Set Network Sharing (SAMBA server) service On/Off.
Note:
Network Sharing option will automatically be hidden if the
internal HDD is absent.
System
Menu Language
Select the language used to display the OSD menus and information.
Text Encoding
Select a language code page for additional ANSI local code subtitle support.
Restore Default
Reset all settings to default values.
System Upgrade
Upgrade system firmware.
Version
Show system firmware version.
To Next Page
Loading...
