ViewSonic
VOT120 25
Chapter 5
FAQ & Troubleshooting
Frequently asked questions
Q1: How to change Boot device from HDD to other bootable devices?
A1: When seeing POST message, press “F11” to load BBS table then to select the
bootable device you plugged in.
Q2: How to use the e-SATA device in VOT120?
A2: the e-SATA connector for the VOT120 does not support a hot plug device, you
have to plug it in before you boot the system. Please note if you’re using 3.5” HDD,
please provide extra power input for the HDD.
Q3: How to set the WOL (Wake on LAN) function?
A3: The WOL function is the default support for the VOT120 so you do not have to do
any modification setting in VOT120 BIOS.
Q4: How much current is provided from the VOT120 USB ports?
A4: 500mA
To Next Page
Loading...
