8
Power On/O
Using power cord
1. Connect the power cord to the power adapter.
2. Connect the AC power cord to a power source
3. Connect the DC power connector to your projector.
Charge the projector for 4.5 hours before using it in battery mode for the rst time.
IMPORTANT!
• Use only the bundled power adapter to change the battery pack and supply power to your LED projector.
• Ensure that your LED projector is connected to the power adapter before turning it on for the rst time.We
strongly recommend that you use a grounded wall socket while using your LED projector on power adapter
mode.
• The socket outlet must be easily accessible and near your LED projector.
• To disconnect your LED projector from its main power supply, unplug your LED projector from the power
socket.
Warning
Read the following precautions for your LED projector’s battery.
• The battery used in this device may present a risk of re or chemical burn if removed or disassembled.
• Follow the warning labels for your personal safety. • Risk of explosion if battery is replaced by an incorrect
type.
• Do not dispose of in re. • Never attempt to short-circuit your LED projector’s battery.
• Never attempt to dissemble and reassemble the battery.
• Discontinue usage if leakage is found. • The battery and its components must be recycled or disposed of
properly.
• Keep the battery and other small components away from children,
To Next Page
Loading...
