Filling and Powering Up Your Swim Spa
1. Inspect the swim spa equipment.
Inspect all plumbing connections in the equipment
area of your swim spa.
Make sure unions in the equipment pack are tight.
(Be careful not to over-tighten the plumbing fittings.)
Never run the swim spa with the gate closed valves or without water
circulating for long periods of time.
2. Remove the cartridge from filter canister.
Grip the filter by the handle and unscrew it from the canister.
Never try to pull the filter cartridge while the swim spa is
running in low or high speed (i.e., any speed).
After you remove the filter, remove the plastic wrapper and soak it in water for
30 minutes before you replace it. A dry filter can allow air into the filtration
system which can cause the pump to fail to prime.
2
To Next Page
Loading...
