Page 4 For technical questions, please call 1-888-866-5797. 59531
SAFETY OPERATION MAINTENANCESETUP
6. People with pacemakers should consult their
physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure.
Service
Have your Jump Starter serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the Jump Starter is maintained.
Jump Starter Safety Warnings
1. Lead-acid batteries generate hydrogen gas when
charging. Hydrogen gas is explosive. Only use
the Jump-Start system in a well-ventilated area.
2. Jump Starting A Vehicle
a. Use the Jump Starter for jump starting
a LEAD-ACID battery only.
b. For emergency use only. Do not use the Jump
Starter as a replacement for a vehicle battery.
c. Be sure area around battery is well ventilated
while battery is being jump started.
d. NEVER jump start a frozen battery.
e. Do not attempt to jump start a vehicle with
a non-rechargeable or defective battery.
f. Study all battery manufacturer’s specific
precautions for jump starting.
g. DO NOT TOUCH POSITIVE AND NEGATIVE
BATTERY CLAMPS TOGETHER.
h. Unplug the Jump Starter from its Adapter
before connecting its cables to a battery.
i. Connect and disconnect battery cable
clamps only after setting any Jump Starter
switches to OFF position.
j. Connect cables to proper polarities. Connect
black cable to negative body ground and
red cable to positive battery terminal.
k. Locate Jump Starter as far away from
battery as battery cables permit.
3. Maintain labels and nameplates on the Jump Starter.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
4. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE INSTRUCTIONS.
Specifications
Input 120 VAC, 60Hz, 0.3A
Cranking Amps 350A
Battery 12 VDC, 9Ah
Battery Cables 24″ L 6AWG
Maximum Air Pressure 150 PSI
Outlets
USB: 1x5V, 2.4A
12V Auxiliary: 1x10A
Functions: 12 Volt Jump-Starter, Air Compressor,
12 VDC Power Supply, and 3 LED Work Light, USB Power
To Next Page
Loading...
