Page 9For technical questions, please call 1-888-866-5797.59531
SAFETYOPERATIONMAINTENANCE SETUP
3. Insert the adapter into the object’s receptacle.
4. Press the Air Compressor Switch on.
Note: Monitor the Air Pressure Gauge on the
front of the unit to avoid over-inflation.
5. When the proper inflation level has been
reached, press the Air Compressor Switch off.
6. Remove the Air Hose.
WARNING! TO PREVENT SERIOUS
INJURY: Do not overinflate any object.
Using DC Appliances
1. Press the Battery Test Button to verify that the
Jump Starter is fully charged. Recharge as
needed, following the instructions in the “Charging
the Jump Starter” section on page 6.
2. Make sure the total wattage of the appliance is
within the range of the Jump Starter. See “DC
Appliance Compatibility” on page 7.
3. Make sure that the Clamp Power
Switch and appliance are off.
4. Plug the appliance into the 12VDC Outlet.
5. Turn on the appliance.
6. When finished using, turn off and
unplug the appliance.
Using/Charging USB Devices
1. Press the Battery Test button to verify that the
Jump Starter is fully charged. Recharge as
needed, following the instructions in the “Charging
the Jump Starter” section on page 6.
2. Plug the device into the USB Port.
3. When finished, unplug the device from the USB Port.
Note: To prolong Jump Starter battery life,
keep Jump Starter battery fully charged.
To Next Page
Loading...
