2
Refrigerator Safety
Installation Requirements
Tools and Parts
IMPORTANT:
Observe all governing codes and ordinances.
•
Installer:• Leave Installation Instructions with homeowner.
Homeowner:
• Keep Installation Instructions for future reference and for the local electrical
inspector’s use.
Keep cardboard shipping piece or plywood under refrigerator until it is installed in the
•
operating position.
Comply with installation specifications and dimensions.
•
Remove any moldings or decorative panels from kitchen cabinets that would not allow access •
to the refrigerator for service.
Contact a qualified electrical installer.
•
TOOLS NEEDED:
Gather the required tools and parts before starting installation. Read and follow the instructions
provided with any tools listed here.
Cordless drill •
•
5
⁄16” or adjustable wrench
•
1
⁄4” Nut driver and drill bit •
7
⁄16” and ¹⁄2” Open-end wrenches
Flat-blade screwdriver • Two adjustable wrenches
•
•
3
⁄8” and ¹⁄2” Socket wrenches
PARTS NEEDED:
•
1
⁄4” (6.35 mm) copper tubing with shutoff valve and a
1
⁄4” (6.35 mm) compression fitting (coupling).
• Depending on water line connections, you may also need a
1
⁄4” (6.35 mm) nut and
1
⁄4” (6.35 mm)
ferrule.
To Next Page
Loading...
