cycle data -
DFUD042 AND DFUD142
DESCRIPTION WATER TEMP. PRE-WASH MAIN WASH RINSE
Pots/Pans 140
0
F or 170
0
F2 1 3
(60
0
C or 75
0
C)
Heavy 130
0
F or 160
0
F2 1 2
(55
0
C or 70
0
C)
Normal 130
0
F or 150
0
F 1 or 2 1 2
(55
0
C or 65
0
C)
Light/China 105
0
F or 120
0
F__ 1 2
(40
0
C or 50
0
C)
Quick 85
o
F or 120
0
F__ 1 2
(30
o
C) or 50
0
C)
Rinse/Hold __ __ 1
AA..
Using the lower water temperature setting.
BB..
Using the higher water temperature setting.
NNOOTTEE::
Includes time for dry
Express option avaliable for Pots/Pans, Heavy, Normal, and Light/China cycles on DFUD142 model only.
Reduces washing time and lowers temperature (not available on Quick wash or Rinse/Hold)
Total Wash Time - Minutes
Input Water Input Water
60
0
F (10
0
C) 120
0
F (49
0
C)
DESCRIPTION NORMAL DRYING OPTION Total Water Gal (L) A B A B
Pots/Pans yes 4.5 230 240 190 195
Heavy yes 4.5 210 220 175 185
Normal yes 4.5 130 150 110 135
Light/China yes 2.4 110 115 85 90
Quick yes 2.1 25 15
Rinse/Hold yes 0.8 4 4
CHANGING A PROGRAM AFTER THE UNIT HAS STARTED
WARNING: Depending on cycles/options selected, the dishwasher operates at very high temperatures. If
opening the door is required during a cycle, use extreme caution. Door should be opened just enough to stop
the wash cycle. Once wash arms have stopped (wait at least 10 seconds), door can be opened. Use extreme
caution since hot steam may be released when door is opened.
The dishwasher is programmed to stop operating if the door is opened during a cycle. If you want to change a
program or option after starting the machine, open the door slightly to let the spray arms stop rotating and avoid
getting sprayed with water. Press and hold START for three seconds to cancel the current selection then press the
touchpad(s) for your desired selection. Press START again and close the door. The drain pump will run to remove any
dirty water from the dishwasher before starting the newly selected cycle. Check to make sure there is still detergent in
the detergent dispenser.
WHEN THE WASH IS FINISHED:
The indicator lights will come on for the last wash program and options that you used. (NOTE: The unit will not retain
the Rinse/Hold or Quick program.)
10
To Next Page
Loading...
