Why is the cutting height adjustment stiff on my Viking Lawn Mower?
If the cutting height adjustment on your Viking Lawn Mower is stiff or not functioning, the height adjustment spring might be defective; replace it. Another possibility is a defective detent segment, which you should also replace. Finally, the translatory lever could be defective; check and replace it if necessary.
General| Cutting Width | 53 cm |
|---|---|
| Rated Power Output | 2.6 kW / 3.5 PS |
| Cutting Height | 25-85 mm |
| Weight | 46 kg |
| Start | Recoil start |
| Engine Type | 4-stroke |
| Cutting Height Range | 25-85 mm |
| Grass Collection | Yes |
| Displacement | 190 cm³ |
| Cutting Height Adjustment | Central |
Procedure for replacing the upper section of the handlebar assembly.
Steps to remove and install the lower handlebar sections.
Guide for replacing the handlebar height adjustment mechanism.
Steps to replace the control bar for the wheel drive system.
Procedure for replacing the motorstop control bar.
Guide to replace the control bar for blade stop and quick start.
Steps for replacing the blade clutch and quick-start lever assembly.
Steps to replace the Vario or three-speed lever.
Guide for replacing the throttle lever assembly.
Steps to remove and install the front axle assembly.
Procedure for replacing the rear axle, including the gearbox.
Guide for removing and installing the front and rear wheels.
Steps for removing and installing the main housing components.
Procedure for replacing the main engine cover assembly.
Steps to replace the handle for adjusting cutting height.
Steps for removing and installing the main gearbox assembly.
Detailed instructions for replacing the lawn mower blade.
Procedure for replacing the blade mounting assembly.
Instructions for deactivating the Quick-Start system before repairs.
Steps to remove and install the engine V-belt.
Guide for removing and installing the entire engine assembly.
Procedure for replacing blade clutch and Quick-Start cables.
Guide for replacing Vario/three-speed control cables.
Fault diagnosis and common solutions for operational issues.
Schedule and procedures for routine maintenance tasks.
Table of specified torque values for various fasteners.
To Next Page
