89
DEFRNLIT EN
0478 131 9920 C - EN
9.1 Notes on initial installation
An installation assistant is
available for installation of the
robotic mower. This program
guides you through the entire
initial installation process:
● Setting the language, date and time
● Installing the docking station
● Routing the perimeter wire
● Connecting the perimeter wire
● Linking the robotic mower and docking
station
● Checking installation
● Programming the robotic mower
● Completing initial installation
The installation assistant must be worked
through in its entirety. Only then is the
robotic mower ready for operation.
Preparatory measures:
● Mow the lawn using a conventional
lawn mower prior to initial installation
(ideal grass height of 3 to 4 cm).
● In the case of a hard and dry surface,
water the mowing area lightly in order to
make it easier to drive in the fixing pins.
9.2 Installing the battery
● Set the lowest cutting height (level 1).
(Ö 9.3)
● Place the robotic mower on its back on
a suitable surface.
Insert the battery (C) as illustrated and
allow it to engage.
Fit the cover (I) and tighten the screws (J).
Observe a maximum tightening torque of
1-2Nm.
9. Initial installation
An installation video is available
at the www.viking-garden.com
homepage.
Your VIKING specialist dealer also
has further information on installing
the robotic mower.
The installation assistant is re-
activated following a reset (reset to
factory defaults). (Ö 10.16)
When navigating through the
menus, follow the instructions in the
section entitled "Operating
instructions". (Ö 10.1)
You can select options, menu items
and buttons using the control pad.
You can open submenus and
confirm selections using the
OK button.
Use the Back button to
leave the active menu or
jump one step back in the
installation assistant.
If errors or faults occur during initial
installation, a corresponding
message appears in the display.
(Ö 23.)
Lithium-ion batteries must be
treated with particular care. VIKING
recommends that you have the
battery installed by a VIKING
specialist dealer. A defective
battery must only be replaced by a
VIKING specialist dealer.
The battery remains permanently
installed in the robotic mower,
removal is only necessary prior to
disposal of the machine. (Ö 19.1)
To Next Page
