TOPSIDE FUNCTIONS
JETS
Press the “Jets” button once to activate the low speed of the pump and
again for the high speed. Press the “Jets” button again to turn off the
pump. If left running, the low speed of the pump will automatically
turn off after 4 hours, and the high speed will automatically turn off
after 15 minutes.
LIGHT
Press the “Light” button to turn the light on and off. If left on, the light
automatically turns off after 4 hours. For the V300 with LED light
and V500 with LED perimeter lighting, press the light button consecu-
tively to change the color sequencing.
MODE
The mode is changed by pressing the “Temp” button, then pressing the
“Light” button.
Standard Mode is programmed to maintain the desired
temperature. Note that the last measured spa temperature displayed
is current only when the pump has been running for at least 2
minutes. “St” will be displayed momentarily when you switch into
Standard mode.
Economy Mode heats the spa to the set temperature only during
filter cycles. “Ec” will display solid when temperature is not current,
and will alternate with temperature when temperature is current.
Sleep Mode heats the spa to within 20°F/10°C of the set
temperature only during filter cycles. “SL” will display solid
when temperature is not current, and will alternate with temperature
when temperature is current.
Preset Filter Cycles. The first filter cycle begins 6 minutes after
the spa is energized. The second filter cycle begins 12 hours later.
Filter duration is programmable for 1, 2, 3, 4, 5, 6, 7 or 8 hours
indicated by “FC”. The default filter time is 1 hours. To program,
press “Temp,” then “Jets.” Press “Temp” to adjust. Press “Jets” to
exit programming.
NOTE
The pump will activate for 1 to 2 minutes to check temperature every
30 minutes or whenever the set temperature is raised.
11
To Next Page
Loading...
Need help?
General
