OPERATION INSTRUCTIONS
ACTIVATE WATER PUMP
Press the jet button on the control board. The high-speed pump will
come on.
Press the jet button again to turn the water to low speed.
Check for water leaks at unions and/or fittings on your equipment
while pump is running.
POWER SYSTEM FEATURES
The power system is located under the skirt. The equipment can be
serviced by simply removing the access panel screws.
It is very important to make sure that the spa is filled up to the proper
level (note the water level mark on the skimmer face) before operating
spa. Make sure the gate valves are in the open or up position.
WARNING: Do not run spa with gate valves closed or run pump with
no water circulating in spa for long periods. Damage could occur to
the spa equipment.
NOTE: The V100, V300 & V500 spas are 120V Only.
8
To Next Page
Loading...
Need help?
General
