2726
1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice
produced. Allow 3 days to completely fill the ice container.
Complete the Installation
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Locate water filter compartment. The compartment is
located in the upper right corner of the refrigerator. Push
tab on compartment to release latch and pull downward.
Unscrew and remove the water filter blue
bypass cap.
Insert filter cartridge into filter housing. Rotate
clockwise gently until filter stops.
Close water filter door.
NOTE: Allow 1-2 minute delay in water dispersal to
allow internal water tank to fill.
IMPORTANT:
After connecting the refrigerator to a water source,
flush the water system. Use a sturdy container to
depress and hold the dispenser lever for five seconds,
then release it for five seconds. Repeat until water
begins to flow. Once water begins to flow, continue
depressing and releasing the dispenser lever (five
seconds on, five seconds off) for an additional five
minutes until a total of 4 gal. (15L) has been dispensed.
This will flush air from the filter and water dispensing
system. Additional flushing may be required in some
households. As air is cleared from the system, water
may spurt out of the dispenser.
Water Filter Installation
Remove toe grille. Grasp firmly and pull outward to
unclip.
To raise left side door, turn leveler foot
screw clockwise.
Door Alignment (French Door Bottom-Mount)
To raise left side door, turn leveler foot
screw clockwise.
Replace toe grill. Align the toe grille mounting clips
with the lower cabinet slots. Push the toe grille firmly
until it snaps into place.
To Next Page
Loading...
