• to cancel the association with the selected position (visible only if the position is programmed).
Association of an internal unit
Selection of intercom type
In this condition, on the internal unit that is to be called, press a key that can be identied unequivocally. It
is advisable to use a key that controls opening of a lock, but you can also use a key that operates a relay or
controls one of the F1 or F2 outputs of an external unit. If the internal unit that is to be called has a handset, it
is advisable to use the lock with the handset replaced.
Once the association has been made, the basic menu of the Intercom context will appear as follows (the internal
unit to be called is number 4):
Awaiting association of the internal unit to be called
Association of a porter switchboard
To Next Page
Loading...
