27
EN
5.4. Call information
The device returns the status information associated with the call phase:
Calling Talking
Call ended
No answer
DeleteBack
Delete
Back
Concluded
Porter
No Reply
If the system is busy, with another call, the wait signal is returned:
Busy
If the user is busy or has set the user absent service, these warnings are issued:
Busy
Absent
5.5. Entry control
When there is a keypad on the panel, the display shows the feedback of the operation of the entry control mode.
This mode lets you activate a previously congured command (e.g. lock, relay, etc.).
For its operation, please refer to the instructions of the keypad module, summarized here.
To Next Page
Loading...
