EN
3
Roxie: 40170
1 General information
Outdoor station for Due Fili Plus system to be completed with push buttons (accessories), from 1 to 4 call buttons.
1.1 Warnings and advice
Warnings for installation:
For installation, refer to the instruction sheet in the package.
Make any system changes (replacement of outdoor stations, new wiring, etc.) with the outdoor station switched o.
Remove the protective lm from the camera lens only once installation is complete.
Maintenance:
Clean using a soft cloth.
Do not pour water onto the appliance and do not use any type of chemical product.
Warnings for the user:
Do not open or tamper with the appliance.
In the event of faults, contact specialized personnel.
Advice on system conguration
If there is an IoT connected Gateway in the system and the entrance panel connectivity with the Bluetooth network of the View
Wireless system is always guaranteed (there are no problems of signal coverage with the IoT connected Gateway or there is a
system node near the entrance panel), having suitably congured the entrance panel with the View Wireless app you can open the
lock from the View app via the home automation system. The IoT connected Gateway will automatically recognise the entrance
panel as a possible opening in your home automation system. One example of use is an entrance panel on the landing outside the
oce.
If the connection of the entrance panel to the Bluetooth network of the View Wireless system is not guaranteed, then an
independent access control video door entry system must be created with the app View Wireless app for the entrance panel/s
(without connection to the IoT connected Gateway). One example of use is an entrance panel at the end of a path, far from the
building and without a strong Bluetooth connections to the View Wireless system.
If you do not have a View Wireless home automation system but a By-Me home automation system with a video door entry
gateway, the entrance panel will be added to the video door entry system.
If you have an indoor station connected via Wi-Fi network, you can control the functions supported by your video door entry indoor
station via the View app (e.g., lock release from the app, self-start, …)
To congure the device from the app, follow the steps described in the “Conguration and commissioning procedure with standard
Bluetooth technology”, in the chapter “Conguration and commissioning procedure” of the View Wireless manual.
To Next Page
Loading...
Need help?
General
