12
ACTO
The undersigned, representing the following manufacturer
Vimar SpA
Viale Vicenza, 14 - 36063 Marostica (VI) Italy
herewith declares that the products
Electronic control unit
Articles
Trade Mark Type ref. Cat. ref. Description
Elvox RS20 RS20 Dip switch and trimmer electronic control card with built-in 433 MHz radio receiver for 230 Vac sliding automatic
gate systems for ACTO 510A and ACTO 810A operators
are in conformity with the provisions of the following EC directive(s) (including all applicable amendments) and that
the following standards and/or technical specications have been applied
Machinery Directive 2006/42/EC
LV Directive 2006/95/EC: EN 60335-2-103 (2003) + A11 (2009)
EMC Directive 2004/108/EC: EN 61000-6-1 (2007), EN 61000-6-3 (2007) + A11 (2011)
R&TTE Directive 1999/5/EC: EN 300 220-2 (2012), EN 301 489-3 (2013)
Further hereby declares that the product must not be put into service until the nal machinery into which it is to
be incorporated has been declared in conformity with the provisions of Directive 2006/42/EC, where appropriate.
Declares that the relevant technical documentation is compiled by Vimar SpA and in accordance with part B of An-
nex VII of Directive 2006/42/EC and the following essential requirements of this Directive are applied and fullled:
1.1.1, 1.1.2, 1.1.3, 1.1.5, 1.1.6, 1.2.1, 1.2.2, 1.2.6, 1.3.1, 1.3.2, 1.3.3, 1.3.4, 1.3.7, 1.3.8, 1.3.9, 1.4.1, 1.4.2, 1.5.1,
1.5.2, 1.5.4, 1.5.5, 1.5.6, 1.5.7, 1.5.8, 1.5.9, 1.6.1, 1.6.2, 1.7.1, 1.7.2, 1.7.3, 1.7.4.
I undertake to make available, in response to a reasoned request by the national authorities, any further supporting
product documents they require.
Marostica, 18/02/2016
The Managing Director
Note: The contents of this declaration correspond to what declared in the last revision of the ofcial declaration available before printing this manual. The text herein has been
re-edited for editorial purposes. A copy of the original declaration can be requested to Vimar SpA
EC DECLARATION OF CONFORMITY
(Declaration of incorporation of partly completed machinery annex IIB 2006/42/EC)
No. : ZDT00664.00
EN