VINCI EXPRESS 2 COLD BREW MAKER - Care and Cleaning

9 10
PRESS
TO
PURGE
CARE AND CLEANING
CONTROL LID
DO NOT SUBMERGE
IN WATER
IMPORTANT: After every use, wash all parts to ensure that the unit will be working like new.
9
BREWING PROCESS
CONTROL LID TO CUP
10
11 12
PURGE
SERVING LID
1
2 3
Once the cycle is complete, the Brew button
will illuminate white and you’ll hear three short
beeps, signaling that your brew is ready!
Upon completion of the brew cycle, partially
lift the Control Lid Assembly(D) and press the
Brew button, the pump will run and purge the
remaining cold brew from the Filter Basket.
After about 20 seconds, press the Brew button
again to stop the pump.
Place Control Lid Assembly(D) into the Cleaning
Cup(H). For detailed cleaning instructions, refer
to the ‘Care and Cleaning’ section on page 10.
Place the Serving Lid(G) on the Carafe(E).
You are now ready to serve your cold brew or
store it in the refrigerator for up to 10 days.
IMPORTANT
REMOVE FILTER BASKET
REMOVE LID FROM CUP
DISCARD COFFEE
IMPORTANT: Never submerge the Control Lid(A)
in water. Doing so will damage the unit and void
the warranty.
Remove the Control Lid Assembly(D) from the
Cleaning Cup(H).
Remove the Filter Basket Assembly(C) from the
Control Lid(A) by rotating it counterclockwise
and then remove the Top Filter Cap(C1) from the
Filter Basket(C3).
Over a trash or compost bin, invert the Filter
Basket(C3), remove the Bottom Filter Cap(C4),
and dispose of the used coffee. After disposing
of used grounds rinse all parts.
REMOVE
CONTROL LID
ASSEMBLY AND
PLACE INTO
CLEANING UP
INSERT
SERVING LID
ROTATE OPEN
TO SERVE OR
CLOSED TO
PRESERVE
ENJOY!
REMOVE
CONTROL
LID FROM
CLEANING CUP
REMOVE FILTER
BASKET AND
REMOVE THE
TOP CAP
REMOVE
BOTTOM CAP
AND DISCARD
COFFEE
RINSE