Need help?Do you have a question about the Vingtor Stentofon TCIS-3 and is the answer not in the manual?
General| Brand | Vingtor Stentofon |
|---|---|
| Model | TCIS-3 |
| Category | Intercom System |
| Language | English |
Outlines the manual's scope for Turbine intercom setup and configuration.
Specifies the required firmware version for the manual's procedures.
Introduces and illustrates various Turbine Compact IP Intercom models.
Introduces and illustrates various Turbine Extended IP Intercom models.
Details the connectors on Turbine Compact stations for various functions.
Details the connectors on Turbine Extended stations.
Details the connectors on Turbine Ex stations.
Guides on connecting accessories like handsets and microphones.
Steps to access the station's web interface for configuration.
Configuration of station mode, IP parameters, and model selection.
Configuration of audio parameters like volume, microphone sensitivity, and ANC.
Configuration of Input/Output pins for various functions.
Management of station address book entries and display settings.
Configuration of display text, font size, and brightness for OLED screens.
Configuration of sound detection parameters for station activation.
Configuration of NTP, time zone, and manual date/time settings.
Steps to access the Edge Controller's web interface.
Configuration of the Edge Controller mode and station parameters.
Guides on connecting and auto-discovering intercom stations.
Setting up station numbers, names, and IP addresses in the directory.
Checking the registration status of devices in the Edge Controller system.
Optional configuration of call and audio parameters for stations.
Defining and assigning station profiles with service features.
Configuration and operation of group calls within the IC-EDGE system.
Steps to access the station's web interface for SIP configuration.
Configuration of station mode and IP parameters for SIP.
Configuration of SIP account details and call settings.
Configuration of audio parameters for SIP stations.
Configuration of DAKs, inputs, and ring list functions for SIP.
Configuration of relay and output behavior based on events.
Configuration of NTP, time zone, and manual date/time for SIP.
Uploading and configuring audio messages for SIP stations.
Configuration of SNMP for network management.
Configuration of IEEE 802.1X for network authentication.
Configuration of firewall rules for network security.
Requirements for performing a software upgrade.
Step-by-step guide for software upgrades using the web interface.
Details the status LEDs on the front panel of stations.
Details the status LEDs located on the Printed Circuit Board (PCB).
Explains the Ethernet activity and speed indicator LEDs.
Steps to reset with DHCP enabled.
Steps to reset with static IP configuration.
Details connectors on the front of the compact PCB.
Details the input connectors on the compact board.
Details output connectors and a relay on the compact board.
Details output connectors and the MRBD relay board.
Details connectors on the rear of the compact PCB.
Details connectors on the front of the front board.
Details connectors on the rear of the front board.
Details connectors on the front of the extended PCB.
Details the input connectors on the extended board.
To Next Page
