Need help?Do you have a question about the Vingtor Stentofon TMIS-2 and is the answer not in the manual?
General| Audio Codecs | G.711, G.722 |
|---|---|
| IP Rating | IP66 |
| IK Rating | IK08 |
| Microphone Type | Electret |
| Power Supply | 24 V DC |
| Audio Frequency Response | 300 Hz |
| Ethernet | 10/100 Mbps |
| Protocols | SIP |
| Operating Temperature | -25°C to +55°C |
| Relative Humidity | 95% non-condensing |
| Housing Material | Aluminum |
| Protection Class | IP66 |
| Mounting Type | Flush mount |
Outlines the document's scope, describes setup procedures, and specifies the firmware version for Turbine IP Intercoms.
Details various Turbine Compact and Extended Intercom models, including their features and connections.
Describes power, network, and I/O connectors for different Turbine station types.
Explains how to connect accessories like handsets and microphones to the intercoms.
Covers main settings and login procedures for ICX-AlphaCom, IC-EDGE, and SIP configurations.
Configures network settings (SNMP, 802.1X), and details the station software upgrade process.
Explains station LEDs, factory reset procedures, and board connector details.
Details the procedure for upgrading station software using the web interface and TFTP.
Explains status indications provided by front plate and PCB LEDs for various station states.
Provides steps to reset the station to factory defaults using DHCP or static IP.
Details the front PCB layout and input connector pin assignments for compact boards.
Details the front PCB layout and input connector pin assignments for extended boards.
To Next Page
