_____________________________________________________________________________________
7.3 Settings of the different parameters
The various parameters are set by pressing the "CONFIG"
key. The configuration menu is displayed. The backlight
flashes in the adjustment mode. Pressing the "+" and "-"
keys navigates the menus.
There are 10 menus available:
Menu 1: Setting the time
Menu 2: Setting the date
Menu 3: Setting the alarm time
Menu 4: 12H/24H mode display
Menu 5: DMY or MDY date display
Menu 6: Configuring the alarm type
Menu 7: Setting the flashing type
Menu 8: Type of luminosity of the vacuum tubes
Menu 9: Backlight brightness type
Menu 10: Backlight color
Pressing the "OK" button validates the selected menu.
Pressing the "CONFIG" button exits the setting menu and
returns to the initial display mode of the clock.
Menu 1 : Setting the time
By default, the time is set to 00H00M00. The "+" key
quickly advances the time, the "-" key slowly decreases the
time. Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button exits the menu without
validating the setting.
Menu 2 : Setting the date
By default, the date is set to 01/01/2017. The "+" key
quickly advances the date, the "-" key slowly decreases the
date. Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button exits the menu without
validating the setting.
Menu 3 : Setting the alarm time
By default, the alarm time is set to 00H00M00. The
"+" key quickly advances the time of the alarm, the
"-" key slowly decreases the time of the alarm.
Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button exits the menu
without validating the setting.
Menu 4 : 12H/24H mode display
By default, the "24H" mode is active. The "+" key
changes from "24H" mode to "12H" mode. The "-"
key changes from "12H" mode to "24H" mode.
Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button exits the menu
without validating the setting.
Menu 5 : DMY or MDY date display
By default the mode "DD/MM/YY" is active. The "+"
key changes from "DD/MM/YY" mode to
"MM/DD/YY" mode. The "-" key changes from
"MM/DD/YY" mode to "DD/MM/YY" mode. Pressing
the "OK" button confirms the setting, pressing the
"CONFIG" button exits the menu without validating
the setting.
Menu 6 : Configuring the alarm type
There are 3 types of alarms:
Mode 1: The backlight is flashing white.
Mode 2: A sound signal sounds
Mode 3: The backlight flashes and an audible
signal sounds.
By default, mode 3 is selected. The "+" key increases
the mode to 3. The "-" key decreases the mode until
1. Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button leaves the menu
without validating the setting.
Menu 7 : Configuration of the flashing type
The separators can flash or stay fixed in 3 different
ways:
Mode 1: Fast flashing, 1Hz
Mode 2: Slow flashing, 0.5Hz
Mode 3: No blinking, stays on.
To Next Page