Vintech Technology Clock C100 - Maintenance

CLOCK C100 – Vacuum tube clock VFD
_____________________________________________________________________________________
User Manual - EN 6
By default, mode 2 is selected. The "+" key increases the
mode to 3. The "-" key decreases the mode until 1. Pressing
the "OK" button confirms the setting, pressing the
"CONFIG" button leaves the menu without validating the
setting.
Mode 8 : Type of the luminosity of the vacuum tubes
There are 2 types of brightness:
 Mode 1: Variable brightness, depending on the
ambient brightness.
 Mode 2: Fixed brightness, to be adjusted.
By default, mode 2 is selected, the brightness of the tubes
is fixed at 70%. The "+" key increases the mode to 2. The "-"
key decreases the mode until 1. Pressing the "OK" button
confirms the setting, pressing the "CONFIG" button exits
the menu without validating the setting.
If mode 2 is selected, a number appears corresponding to
the light output of the tubes. The "+" key increases the light
output up to 99%. The "-" key decreases the light output by
up to 1%. Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button exits the menu without
validating the setting.
Mode 9 : Type of backlight brightness
There are 2 types of backlight brightness:
 Mode 1: Variable brightness, depending on the
ambient brightness.
 Mode 2: Fixed brightness, to be adjusted.
By default, mode 2 is selected, the brightness of the
backlight is fixed at 30%. The "+" key increases the mode to
2. The "-" key decreases the mode until 1. Pressing the
"OK" button confirms the setting, pressing the "CONFIG"
button exits the menu without validating the setting.
If mode 2 is selected, a number appears corresponding to
the backlight's light output. The "+" key increases the light
output up to 99%. The "-" key decreases the light output by
up to 1%. Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button exits the menu without
validating the setting.
Mode 10 : Backlight color
There are 2 types of settings available:
 Mode 1: Variable colors
 Mode 2: Fixed color, to be adjusted.
By default, mode 1 is selected. The "+" key increases
the mode to 2. The "-" key decreases the mode until
1. Pressing the "OK" button confirms the setting,
pressing the "CONFIG" button exits the menu
without validating the setting.
If mode 2 is selected, a number appears
corresponding to the color of the backlight. The "+"
key increases the color number up to 48. The "-" key
decreases the color number to 1. The color appears
according to the chosen number. Pressing the "OK"
button confirms the setting, pressing the "CONFIG"
button exits the menu without validating the
setting.
8. Maintenance