Vinten Vector 700 - Page 71

71
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Fig 6.6 Vector 700/700H (Black) Pan and Tilt Head
- Mechanism Housing Assembly (Cont)
Item Part No Nomenclature Qty
25 3458-19 Tilt drag unit assembly, including 1
26 P302-017 Bearing, ball, radial, 30 mm ID x 42 mm OD x 7 mm long, two seals 1
27 P605-003 Snap ring, external, 30 mm shaft dia. x 1.5 mm thick 1
28 M801-059 Pin, dowel, 3 mm dia. x 12 mm long 2
29 3354-295 Pivot Pin 2
30 M006-714 Screw, cap head, socket, M5 x 25 mm long 2
31 M006-734 Screw, low-profile, cap head, socket, M5 x 10 mm long 2
32 3458-212 Actuator 40mm (left hand) 1
33 3354-288* Lining (Tilt brake reactor) 1
34 3354-265 Actuator shaft 1
35 3354-218 Pinion shaft 1
36 P605-007 Snap ring, external, 20 mm shaft dia. x 1.2 mm thick 2
37 P003-001 Bearing, plain flanged, plastic, 8 mm ID x 10 mm OD x 5.5 mm long 1
38 M004-812 Screw, grub, cone point, socket head, M3 x 5 mm long 2
39 3354-214 Bevel gear (pinion) 1
40 3458-216 Actuator 40mm (right hand) 1
41 3354-209 0.125mm (0.005") Shim. A/R
3354-217 0.075mm (0.003") Shim
3354-433 Shim (0.002")
42 P001-018 Bearing, plain, du bush, 8 mm ID x 10 mm OD x 12 mm long -
43 3448-253 Drag detent ring - tilt 1
44 3448-232* Tilt drag knob moulding / graphic 1
45 M600-006 Washer, plain, heavy, M5 1
46 M006-737 Screw, low-profile, cap head, socket, M5 x 6 mm long 1
47 3354-292 Knob sleeve boss 1
48 P900-008 Ball, steel, 4 mm dia. 2
49 J532-067 Spring, compression, 25 mm free length, 3.50 mm OD x 2.71 mm ID,
1.123 N/mm rate
2
50 L801-105 Pin, dowel, 1/8 in. dia. x 9/16 in. long 1
51 3354-293 Serrated boss