VIOMI S9 - Operation Instructions; Switching the Robot On and Off; Starting and Pausing Sweeping; Automatic and Manual Recharging

Long press power buon for 3 seconds to switch machine on/off.
Power LED indicator flashes slowly for 4 seconds and then lights on
constantly in blue color, and the cleaner in standby. Upon start-up there
is a tone for prompt.
When cleaner stays still, long press the power buon for 3 seconds
to switch it off.
The power LED goes out, and a voice prompt is given.
Cleaner will sleep if being idle for more than 20 minutes. In sleep status,
shorting press any buon will wake it up.
Tips: During recharging, the robot cannot be switched off or sleep.
Operation Instructions
06
1.Switch on/off
In power-on status, short press the buon with voice prompt "start
global cleaning".
During cleaning, short press the buon to cease sweeping.
Tips: At low baery level, sweeping function cannot be started.
2.Sweeping
In case of fault in the vacuum-mop, audible and visual alarms will be
given with power LED indicator flashing in red. For more details refer to
Trouble Shooting.
The vacuum-mop will sleep automatically when being idle for 10 minutes
in case of fault.
6.Fault
Upon end of sweeping, a voice prompt "cleaning finished and recharging
started" is given, and the vacuum-mop starts recharging.
In case of low baery level during sweeping, the vacuum-mop will start
recharging automatically.
3.Automatic/manual recharging
Short press buon to pause the vacuum-mop; remove mopping
module, refill the tank or clean the mop; re-mount the mopping module
and short press the buon again to resume sweeping.
4.Refilling tank or cleaning mop half-way
Download App by scanning the QR code on the machine and reset WiFi
by following the tips on APP.
You can query or update the firmware on App. During update make sure
the machine is being charged with baery level not below 60%. For more
details refer to instruction in the App.
Aer downloading, configure network by following tips on APP. Aer
connecting the machine to network, you can start sweeping or
scheduled cleaning remotely on App.
5.Network configuration and firmware update