18
Treatment Documentation
• Document treatment information and progress throughout the treatment plan.
• Follow the rest procedure guidelines provided with the treatment protocol.
• It is recommended that you take photographs and measure the treatment area:
• Before the first treatment session to establish a baseline
• After the first 2 sessions to document any progress
• Before the last treatment
• Before any maintenance session
Test Procedure
Treatment course should begin only after a test procedure has been performed successfully
and no adverse effects were recorded.
General Treatment Guidelines
Viora strongly recommends the use of sanitary gloves.
Immediately prior to treatment it is recommended to:
• Clean the skin with a hypoallergenic skin cleanser.
• Exfoliate skin with the Pristine™ microdermabrasion system.
• Confirm the desired treatment intensity level in the display panel (see section
5.3 for setting the optimal treatment intensity level).
Understanding Treatment Intensity Levels
Patient sensitivity to Electroporation is affected by a number of physiological attributes like
natural impedance and water content in the skin which vary between patients. Therefore,
comfort zones for each patient are highly individual and treatment intensity levels
must be set accordingly. As higher levels may return better results, it is recommended
that you aim for the highest treatment intensity your patient can comfortably tolerate.
To establish optimum treatment intensity for first time patients:
• Always begin with a treatment intensity level at or below 20%.
• Gradually adjust the treatment intensity level upwards until you establish the
optimal comfort zone for the patient.
5.2
5.3
Treatment may be stopped or paused anytime during the session by pressing
the stop pushbutton located at the front panel.
Note
5.1.4
5.1.5
To Next Page
Loading...