Impact Sensor: a light impact activates
Warn away and a heavier impact activates
full alarm
Interpreting Zone Diagnostics
W
arn Away responses are not reported by arming or disarming
diagnostics. If you receive a Bypass notification when arming or a
Tamper Alert notification when disarming, look at the in-vehicle
status LED. Active or triggered zones will be indicated by a pattern
of blinks by this LED.
For example: If Zone 3 (door) was active or triggered, the in-vehicle
LED will blink three times with a 2-second pause. Then it will blink
three times again and repeat until the ignition is turned on.
If your system has been triggered but the LED has been reset by
turning on the ignition, your dealer can still recall the last zones
that were triggered. Contact your dealer for details.
To Next Page
Loading...
