Viper Responder One - Remote Start

Note:
In
order for
the
ignition controlled
door
locks to work, the feature
must
be turned on
in
programming.
Note:
If
the
ignition
is
turned on while the vehicle
is
remote started
the
doors
do
not lock until the remote start
shuts
off.
To
avoid being locked
out
of
the
vehicle,
do
not
turn
the
ignition on until you are ready to drive
the
vehicle.
Remote
Start
This
feature allows you to remotely start and
run
your vehicle for a
programmable period
of
time.
This
makes
it
possible to warm up the
engine,
as
well
as
adjust
the
interior temperature
of
the
vehicle with
the climate control
system.
If
interior heating or cooling
is
desired, the
climate controls
must
be preset, and the fan blower
must
be
set
to
the
desired level prior to remote starting the vehicle.
lmportantl
( l)
Never
remotely start
the
vehicle with
the
vehicle
in
gear, and
(2)
Never
remotely start
the
vehicle
with
the
key
in
the ignition.
;,,
,,,,,,,
,,,_,,,,,,.,
. .
....
,.,
..
' ·'
....
'
.,.
,.
--
,,
.....
,
..
..•
,.
.............
, .
" ·"
''
"
"""
'
...
,
..
,
..
, ,
,,,
.•
,
..
,.,
..
.,
.
.,
,.,
. ,
....
,.
,.,
'
''"""·
.....
.,
..
,
.....
.
........
...
, ,
..
.,,
To
remote
start
the
vehicle:
l .
Press
the single button on the transmitter once.
2.
The
remote responds with the remote start
On
tones and the green
LED
on
the
remote flashes once.
The
vehicle's parking lights
turn
ON
constant to confirm remote start operation.
3.
Once
the vehicle has started, it
runs
for the pre-programmed pe-
riod
of
time ( 12,
24,
or
60
minutes) or until a shutdown input
is
triggered.
This
can be
set
to minute increments
by
your installer.
To
shut
off
the
remote
start:
While
the
vehicle
is
remote started press and hold
the
button on the
8
©
2011
Directed
Electronics.
All
rights
reserved.