Virtue ION BOARD - Firing Mode; Firing Mode Selection (Purple)

Virtue Ion Board firing mode
7
If you want to change firing modes first determine the number of the
firing mode you want to change to:
1.
Semi Auto: 1 trigger pull equals 1 shot.
2.
PSP Ramping: First 3 shots are Semi Auto. The 4th shot shoots
3 shots per pull at your “Max Rate of Fire”. Let go of the trigger for 1
second and the 3 shot Semi Auto count restarts.
3.3.
NXL Style Full Auto: First 3 shots are Semi Auto. The 4th shot
you hold down the trigger and the marker shoots full auto at your
“Max Rate of Fire”. Let go of the trigger for 1 second and the 3 shot
Semi Auto count restarts.
4. 4.
Ramp Mode: When you reach the “Ramp Activation Speed” the
marker will ramp the rate of fire by your “Ramp Percentage” setting,
up to your “Max Rate of Fire”. The default is when your trigger speed
reaches 5bps, the marker will ramp up to the maximum speed your
loader can feed.
5.
Auto Response: Two shots per pull. One shot on the pull, and
one shot on the release of the trigger.
6.6.
Full Auto: Hold down the trigger and fire at your “Max Rate of Fire”.
7.
Breakout Mode: Turn the gun on and the first shot shoots full
auto as long as you hold the trigger. Release the trigger and the gun
goes in “Ramp Mode”. Restart your marker when in this mode to
repeat the Breakout function.
Then, remembering the number of the firing mode you want to
change to (semi is 1, psp is 2, nxl is 3, etc) do the following steps:
1. With the marker o1. With the marker off, and tournament lock off, hold the trigger and
turn the marker on. Release the trigger once the marker turns on.
2. The LED will cycle through a rainbow of colors and stop on purple.
3. Pull and hold the trigger until the LED flashes (default is semi auto,
so the LED will flash once).
4. When the LED stops flashing, tap the trigger the number of times
of the desired mode (semi is 1 tap, psp is 2 taps, nxl is 3 taps, etc).
5.5. The LED will flash the number of taps you entered, then flash the
rainbow of colors, and stop on purple, indicating the new value has
been set and you are now in the new firing mode.
6. To exit programming mode, shut the marker off.