VIRTUFIT WP200i - Running Belt Adjustment; Training with Fitness Applications; Maintenance

ENGLISH
EN
06
Zwift
APP STORE GOOGLE PLAY MANUAL
MAINTENANCE
Safe and efficient use can only be achieved if the appliance is properly
installed and maintained. It is your responsibility to ensure that the
appliance is maintained regularly. Parts that have been used and/
or damaged must be replaced before the appliance is used again. The
appliance should only be used and stored indoors. Long-term exposure to
weather and temperature/humidity changes can have a serious impact
on the electrical components and moving parts of the unit. Always unplug
the power cord from the unit before cleaning or servicing it.
Daily maintenance
• Clean and remove sweat and moisture after each use.
• Check that the unit is free of dust and dirt.
• Do not use aggressive cleaning agents and keep the device
away from moisture.
Semi-annual maintenance
• Inspect all bolts and nuts connected to the moving parts of the
unit. Tighten bolts and nuts as necessary and appropriate.
• Check the mobility of moving parts and components of the unit.
Use silicone spray if necessary and appropriate.
We recommend the following:
• Clean the unit after use.
• Use a dry cloth to clean the control panel and the areas around
the on/off switch.
• Use a soft, clean cloth and detergent to remove stubborn marks
and dirt from the unit.
• Store the unit in a safe, dry place away from heat and water.
CAUTION!
• Repairs must be carried out by a professional technician,
unless otherwise specified by the supplier or manufacturer.
• To avoid slipping during exercise, the treadmill belt should
well. Repeat the process until the blockage is resolved (3).
EN
Virtufit Totally Foldable TR-50i Treadmill
11
11
NL
INKLAP INSTRUCTIES
-- Pull the pull-pin on the console handrail to fold the console carefully.
-- Pay attention to the cables and ensure that they are nog pinced.
--unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up
--Place the machine leaning against the wall or place under a bed.
CAUTION: Do not allow children to touch the machine, the treadmill may fall.
FOLDING INSTRUCTIONS
1. Pull the pull-pin on the console handrail to fold the console carefully. Pay attention to the cables and
ensure that they are nog pinced.
2. Unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up.
3. Place the machine leaning against the wall or place under a bed.
NOTE: Store your machine in a dry area away from children and high trac areas as shown in the
illustration. Be sure it is secure and cannot fall onto small animals or children.
RUNNING BELT ADJUSTMENT
01. Running belt deviates to left: Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 1). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
02. Running belt deviate to right:
Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 2). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
03. Running belt jam: If the running belt is in dead condition, use the Allen key to turn the screw 1/2 a
turn both left and right until the jam solved (see fig 3).
EN
Virtufit Totally Foldable TR-50i Treadmill
11
11
NL
INKLAP INSTRUCTIES
-- Pull the pull-pin on the console handrail to fold the console carefully.
-- Pay attention to the cables and ensure that they are nog pinced.
--unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up
--Place the machine leaning against the wall or place under a bed.
CAUTION: Do not allow children to touch the machine, the treadmill may fall.
FOLDING INSTRUCTIONS
1. Pull the pull-pin on the console handrail to fold the console carefully. Pay attention to the cables and
ensure that they are nog pinced.
2. Unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up.
3. Place the machine leaning against the wall or place under a bed.
NOTE: Store your machine in a dry area away from children and high trac areas as shown in the
illustration. Be sure it is secure and cannot fall onto small animals or children.
RUNNING BELT ADJUSTMENT
01. Running belt deviates to left: Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 1). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
02. Running belt deviate to right:
Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 2). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
03. Running belt jam: If the running belt is in dead condition, use the Allen key to turn the screw 1/2 a
turn both left and right until the jam solved (see fig 3).
EN
Virtufit Totally Foldable TR-50i Treadmill
11
11
NL
INKLAP INSTRUCTIES
-- Pull the pull-pin on the console handrail to fold the console carefully.
-- Pay attention to the cables and ensure that they are nog pinced.
--unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up
--Place the machine leaning against the wall or place under a bed.
CAUTION: Do not allow children to touch the machine, the treadmill may fall.
FOLDING INSTRUCTIONS
1. Pull the pull-pin on the console handrail to fold the console carefully. Pay attention to the cables and
ensure that they are nog pinced.
2. Unscrew the hand knob on the both sides of the frame respectively and carefully fold the console up.
3. Place the machine leaning against the wall or place under a bed.
NOTE: Store your machine in a dry area away from children and high trac areas as shown in the
illustration. Be sure it is secure and cannot fall onto small animals or children.
RUNNING BELT ADJUSTMENT
01. Running belt deviates to left: Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 1). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
02. Running belt deviate to right:
Start the machine, set speed at 2-3 km/h without a load on the belt,
use Allen key to turn the screw 1/4 turn (see fig. 2). Then allow the machine to run without a load for 1-2
minutes. Repeat process until the belt becomes central.
03. Running belt jam: If the running belt is in dead condition, use the Allen key to turn the screw 1/2 a
turn both left and right until the jam solved (see fig 3).
TRAINING WITH FITNESS APPLICATIONS
VirtuFit does not provide service for third party fitness applications
such as Kinomap, iConsole, FitShow etc. If you encounter problems
with a third party fitness application, please contact the developer
of the application in question.
Instruction
• To scan the QR code with an Android or IOS phone or tablet, a
QR code scanner is required. The app for scanning QR codes can
be downloaded from the App Store or Google Play Store.
• Scan one of the QR codes below to go directly to the App Store or
Google Play Store page where the fitness app can be
downloaded.
• Scan the QR code on the right to access the fitness app
manual. The manual describes step by step how to connect the
fitness app to the device, how the fitness app works and what its
capabilities are.
Fitshow
APP STORE GOOGLE PLAY MANUAL
Kinomap
APP STORE GOOGLE PLAY MANUAL