The units power cable is
connected but doesn’t work
Remote doesn’t work or works
poorly
Satellte cable connected
but no signal
Poor picture
Picture colour is abnormal.
No Sound or poor sound
No Video output
Files not visible, format is not
recognised
USB
Device
• Check power and mains socket switch
is switched on
• Check polarity of batteries agrees with
the markings in the battery compartment
• Fit fresh batteries
• Check the satellite cable connection
• Check dish is correctly aligned and that
the correct satellite is selected.
• Check if signal level and quality is good
• Check the satellite cable connection
and TV connection
• Check satellite receiver and TV are set to
the same picture format (PAL in the UK)
• Check LNB and satellite receiver are set
the same
• Check all audio cables work and are
properly connected.
• Check that Audio output is not muted or
turned down on the receiver or TV.
Make sure the Audio is set to stereo.
• Check sound setting, is set to
digital sound
• Check if the correct signal input source
to the TV is selected.
• Check if all video cables are
connected and working correctly
• Check if the satellite receive is in standby
mode
• Check USB device format is compatible
• Check le format is compatible
Technical Support
For further information visit www.labgear.co.uk
or Email: technical@labgear.co.uk
Troubleshooting
Declaration of Conformity
Hereby, Labgear declares that the radio equipment: Satellite Receiver for
satellite broadcast reception in domestic premises is in compliance with the
Radio Equipment Directive 2014/53/EU. The full text of the EU Declaration
of Conformity is available at the following internet address:
www.labgear.co.uk/DoC
To Next Page
Loading...