Name: Vision 16 Series
Brand: Vision
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Vision 16 Series and 24 Series Engraver User Manual18

5 Table Connections

16 and 24 Series Engraver/Series 4 Controller Connections

1. The engraver's Pendant is connected to the Pendant cable port.

2. The Ethernet Cable from your computer, hub or network is connected to the Ethernet port.

3. The Auxiliary Table Cable is used on the 24 Series engraver ONLY.

4. The Table Cable connects from 25 pin connector on the engraver to the Table port.

5. The Spindle Cable connects to the Spindle port.

6. The Power Cable connects a 110 - 220 VAC electrical source to the controller and powers the

controller, table and spindle.

7. If your machine is equipped with the optional Vacuum Chip Removal System, a remote On/Off cable

is connected to the controller to automatically turn the vacuum pump on and off when the job is being

run.

8. *If your machine is equipped with the optional NSK High Frequency Spindle, an second 25 pin

connector will be included with your controller. The NSK Spindle is controlled by the NSK Spindle Cable

connected to this port. NOTE - the Spindle Cable to the standard engraving motor will not be used in this

configuration.

Series 4 Pendant and Controller

Questions and Answers:

Need help?

Do you have a question about the Vision 16 Series and is the answer not in the manual?

Vision 16 Series Specifications

General