Need help?Do you have a question about the Vision 1612 and is the answer not in the manual?
Details specifications like Z-Axis Clearance, Stroke, and Resolution.
Defines key terms related to Vision tables and their components.
Describes the design and operation of T-slot tables where the table moves.
Describes flatbed tables where the gantry moves along the X-axis.
Instructions for connecting power, cables, and controllers to the engraving system.
Schematic showing cable connections for the High Frequency Spindle.
Schematic showing cable connections for the Porter Cable Router.
Details the components of the Series 3 Top-Loading and Collet Spindle Assemblies.
Step-by-step guide to zeroing cutters using the micrometer for top-loaded spindles.
Instructions for zeroing cutters using collet spindles, including draw bar use.
Explains the proximity sensing device and its operating procedure.
Describes installing diamond drag adapters and performing diamond engraving.
Procedures for chip removal and the optional vacuum system.
Step-by-step instructions for replacing the belt driving the spindle engraving system.
Guidelines for lubricating lead screws, spindle housing, and what not to lubricate.
A suggested schedule for regular maintenance tasks like cleaning and lubrication.
Information on installing optional riser blocks to raise the gantry assembly.
Discusses split collet spindles and diamond drag adapters for enhanced engraving.
Common engraving issues and their potential solutions.
Troubleshooting for mechanical issues affecting system movement and operation.
To Next Page
General
