Troubleshooting 31
© 2013 Vision Engraving & Routing Systems
Problem: Spindle is hot.
Possible solutions:
1. Ensure that the nose cone area is free of debris. Check the vacuum system (if used) for clogging.
2. Inspect the spindle for other obstructions that may prevent proper rotation.
3. Bearings may need to be replaced.
Problem: Spindle motor will not turn on.
Possible solutions:
1. Check the auto/on/off switch to ensure the proper operational mode.
2. Check motor brushes.
Problem: Motor belt will not stay on pulley.
Possible solutions:
1. Motor belt is probably worn and needs to be replaced.
To Previous Page
Loading...
