Vision 1624 Installation Guide

Machine Setup 19
© 2020 Vision Engraving & Routing Systems
Additionally, the Misting System Power Plug on the machine connects to the controller's Pump/Mist port
with the supplied cable.
2.6 Network Connection
NOTE - This following section is shown on a Windows 10 PC. For Windows 7 or Windows 8, the screens
are slightly different.
Plug the USB end of the USB to Ethernet adapter into any open USB port on the computer.

Vision 1624 Specifications

General

Brand	Vision
Model	1624
Category	Engraver
Language	English