User Manual Focal Point
General Information
Issue No: M Page: 2
Ref: FOCL-ASUM-8xxx Copyright © 2017 Vislink plc
DO NOT dispose of any equipment, including batteries, as household waste. The
equipment and batteries are not bio-degradable in landfill sites.
WARNING: DO NOT incinerate Batteries. Batteries can suddenly explode under extreme
temperature and cause personal injury.
Vislink offer a battery disposal service. Before shipping, you are required to advise the
Vislink sales team (Hemel Hempstead, UK) of your intent to return any batteries.
To do this call on: +44 1442 431 300
The equipment is supplied with an AC supply connector and cord assembly. The wires in
the cord are colored in accordance with the following convention:
Table 1-1 AC Input Wire Configuration
Always ensure that the equipment is correctly connected. Failure to connect the
equipment correctly may render protective devices inoperable. If in doubt consult a
qualified electrician.
CAUTION: The front panel DC power switch is a standby function only, some of the
components remain powered.
An AC isolator switch is fitted on the rear panel adjacent to the AC input connector; in
normal use the equipment should be positioned such that this switch remains readily
accessible. To be certain that the equipment is isolated from the AC supply, always unplug
it from the AC outlet.
The FocalPoint System is compliant under the ETSI R&TTE directive.
The Camera Control Data Transmitter is compliant to CE (!). The (!) symbol warns the
operator that the unit is an intentional radiator and that the operating frequency may not
be authorized in some territories. It is your responsibility as the operator to ensure that
you possess the required valid local authority license(s) and site clearances for the
intended operating frequencies, geographical location and times of operation of the
equipment.
You are also responsible for the proper setup, operation and maintenance of the system,
to ensure that it complies with the limits specified by the license.
NOTE: Shielded cables must be used with this equipment in order to ensure that it meets
the emissions limits for which it was designed. It is your responsibility, as the user,
to obtain and use good quality shielded cables with this device. Shielded cables are
available from most retail and commercial suppliers of cables designed to work
with radio equipment and personal computer peripherals.
To Next Page
Loading...
Need help?
General
