SPECIAL FUNCTIONS
18 D-302016
C. Click the
OK
I
button, the display will prompt
you for your user code:
ENTER CODE
_ _ _ _
D. Enter your code. The siren will sound for 2
seconds and the display will change to:
TESTING
E. Walk throughout the protected area and make
sure you trigger every detector with no exception
(move across the field of view of motion
detectors and open/close doors and windows).
Each time a detector is triggered:
• The “Happy Tune” will sound,
• The zone name and number will be displayed
briefly.
EXAMPLE 1: You triggered a motion detector in
the living room (zone 11). The display will show:
P3 LIVING ROOM
P3 Z11 VIOLATED
After 5 seconds the display will revert to:
TESTING
EXAMPLE 2: You opened a window in partition 3
in the guest room (zone 13). The display will show:
P3 GUEST ROOM
P3 Z1
3 OPEN
After 5 seconds the display will revert to:
TESTING
F. When done, click the
button
repeatedly. The display will show the test results,
partition after partition and zone after zone, in
ascending numerical order. For example:
P3 GUEST ROOM
(alternating)
P3 Z13 OK
or: “P3 Z13 NOT OK” if there was no
response from Z13.
G. To resume testing, click
. To quit the test
mode, click
. The display will then read:
<OK> TO EXIT
H. Click
OK
I
. The display will revert to its
normal state.
To Next Page
Loading...
