Visonic PowerMax Xpress - Private Reporting Setup; Setting User Codes

USER SETTINGS
D-302016 21
PRESS
RESULTANT DISPLAY
SET BYPASS
Enter user code
RECALL BYPASS
At this point proceed as follows:
PRESS
RESULTANT DISPLAY
<OK> TO RECALL
OK
I
RECALL BYPASS
OK
I
You may now select any other item on the USER
SETTINGS menu or quit programming by clicking
.
When <OK> TO EXIT is displayed - click
OK
I
.
Report to Private
Here you determine up to 4 telephone and SMS
telephone numbers (to which the system will report
event messages), the events types (alarms, alerts,
alarms+alerts or no report) and redial attempts number.
Having entered your Master User Code
successfully
(see above - Entering the User Settings Menu), click
button repeatedly (if necessary) until the
display will read:
PRIVATE REPORT
PRESS
RESULTANT DISPLAY
REPORT TO PRVT
OK
I
VOICE REPORT
1st private tel#
OK
I
XXXXXXXXX
OK
I
[Enter Tel. No.] XXXXXXXXX
XXXXXXXXX
OK
I
1st private tel#
OK
I
2nd private tel#
Continue the same way up to telephone number 4.
You may now switch to any other item on the USER
SETTINGS menu or quit programming by clicking
until <OK> TO EXIT is displayed and then
clicking
OK
I
.
Setting the User Codes
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
until the display reads:
SET USER CODES
User Code 1 replaces the factory default master
user code, and should be assigned to the master
user of the system. This code can not be erased.
User Codes 2, 3 and 4 can be assigned to additional
users - family members, co-workers etc.
Codes 5 through 8 are assigned to “Latchkey
Users” (see Chapter 2 - Arming in the Latchkey
Mode, for an explanation of the latchkey mode).
Caution! Code “0000” is not valid! Do not use it.
Note: The duress code set by the installer (2580 by
default) cannot be selected as a normal user code. Any
attempt to program it will be rejected by the system.
Master user code is valid for all 4 system partitions. In
PowerMaxExpress with partition feature, user codes 2 -
8 are valid for predefined partitions only.
User codes programming process is as follows:
PRESS RESULTANT
DISPLAY
user code 1: _ _ _ _
OK
I
user code1: 1 1 1 1
OK
I
user code 1: 6854
[4-digit user
code] e.g. 6854)
user code 1: 6854
Programming user
code 1 (master user)
)
OK
I
user code 2
user code 2: 1 1 1 1
OK
I
[4-digit user
code] e.g. 9854)
In PowerMaxExpress Partition system
access to part
OK
I
U02: 1 2 3 4
OK
I
U02: 1
2 3 4
Programming user codes 2 -8 and assigning
them to the desired partitions
Enter partition No.
(e.g. for partition 2&4
enter 24)
OK
I
OK
I