Visonic PowerMax Xpress - Setting Time and Time Format; Setting Date and Date Format

USER SETTINGS
24 D-302016
SQUAWK OPTION
SET TIME&FORMAT US FORMAT - 12H EU FORMAT - 24H
TIME _ _:_ _A TIME _ _:_ _
[time] e.g. 07:55P [time] e.g. 19:55
DATE DD/MM/YYYY DATE MM/DD/YYYY
SET DATE&FORMAT
(1)
(1)
(1)
(4)
if not satisfied
if not satisfied
TIME 07:55 P TIME 19:55
squawk disable
sqwk low volume
sqwk mid volume
sqwk hi volume
(To review options, use
or button)
DATE: _ _/_ _/_ _ _ _ DATE:_ _/_ _/_ _ _ _
(date)
(2)
(date)
(2)
DATE 30/12/2007 DATE 12/30/2007
(e.g. 30/12/2007)
(e.g. 12/30/2007)
<OK> TO EXIT
INSTALLER MODE
(1)
Entrance to INSTALLER
MODE (described in
the installer guide)
























READY
(see top of drawing in previous page)
SET BYPASS / SHOW BYPASS / RECALL BYPASS
(see drawing in previous page)
From drawing in
previous page
Moving forward
Moving backward
Moving one level
up in the menu
Return to
“<OK> TO EXIT”
To move within
most of
the menus, the following
keys can be used:
Show / confirm
data
OKI
OKI
OKI
OK
I
OK
I
OKI
OKI
OKI
OKI
OK
I
OK
I
OKI
OKI
OKI
OK
I
OK
I
OKI
OKI
OKI
Figure 8 - Users Settings Flow Chart
Notes: (1) Functions inside black rectangles are accessible only if master user code was entered.
(2) For the year, enter the two last digits only.
(3) Press
OK
I
to display the number, state and name of first bypassed zone. Press repeatedly to view all the bypassed zones.
(4) To enter "A" (AM) press
(or one of the 3 keys above it), to enter "P" (PM) press (or one of the 3 keys above it).
(5) SET/SHOW/RECALL BYPASS menus are accessible only if "manual bypass has been selected by the installer.
(6)This menu is not available when partition is enabled.
Automatic Arming Option
Note: This menu is valid when operating in non-partition
mode only.
You can determine that the system will be automatically
armed at any desired time.
Having entered master user code successfully, click
until AUTO ARM OPTION is displayed.
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
enable autoarm
OKI
(if this is the current option)
disable autoarm
If not satisfied
press
disable autoarm
OKI
AUTO ARM OPTION
OKI
You may now select any other item on USERS
SETTINGS menu or quit programming process by
clicking
. When "<OK> TO EXIT" is
displayed, click
OKI
.
Setting Arming Time
Note: This menu is valid when operating in non-partition
mode only.
Having entered your Master User Code successfully
(see above - Entering the User Settings Menu), click
button (repeatedly, if necessary) until the
display will read:
AUTO ARM TIME
From here, proceed as follows:
PRESS
RESULTANT DISPLAY
arm time_ _ : _ _ A
OKI
arm time 12:55 A
[time
digits] (e.g.
12:55 A)
arm time 12:55 A
AUTO ARM TIME
OKI
Notes:
1. For 12h/24h time format selection, refer to
Setting Time and Time Format below.
2. Press "" to enter A (AM), or press "#" to enter P
(PM).