USER SETTINGS
20 D-302016
Remember – zone bypassing compromises security!
Note: Zones will be bypassed throughout one
disarm-arm period only. Disarming the system after
arming will suspend the entire bypassing scheme.
B. Bypassing Procedure
For PowerMaxExpress with partition feature, you
may set the bypass option according to the type of
partition access permission.
Having entered your user code
successfully (see above
- Entering the User Settings Menu), the display will read:
SET BYPASS
If at this point you click
OK
I
, the number and state of
the first zone / partition containing the first zone (in
PowerMaxExpress with partition feature) will be
automatically displayed. Three states are then made
possible:
• Open: The zone is not secured - you can
bypass the zone if you do not wish or know how
to solve the problem right away.
• Bypassed: The zone is presently bypassed
(you bypassed it before but have not armed the
system yet).
• Functional: If there is nothing wrong with the
zone, its state is described as "Functional
".
Let us assume that Zone 1 in partition 3 is "open"
and you wish to bypass it, and the rest of the zones
are functional.
PRESS
RESULTANT DISPLAY
Z01 OPEN
OK
I
(alternating)
KITCHEN
OK
I
<OK> TO BYPASS
Z01 BYPASSED
OK
I
(alternating)
KITCHEN
Z02 FUNCTION
(alternating)
FRONT DOOR
(If you wish
to check the
state of the
next zone)
SET BYPASS
You can select any other item on the USER SETTINGS
menu or quit programming by clicking
. When
<OK> TO EXIT is displayed - click
OK
I
button.
At the end of the bypassing operation, BYPASS blinks:
READY BYPASS or NOT READY BYPASS
This indication will persist as long as the system
remains disarmed, and will disappear once the
system is armed.
Note: BYPASS will alternate in the display with other
messages, such as: TRBL, MEM and MSG.
C. "Unbypass" Procedure
Suppose you wish to restore zone 22 of partition 3
after having completed the bypassing scheme. Simply
re-enter the SET BYPASS menu (see Bypassing
Procedure above), and click
or until
the zone you wish to "unbypass” in the desired
zone/partition is displayed. Refer to the following steps.
PRESS
RESULTANT DISPLAY
Z22 BYPASSED
(alternating)
LIVING ROOM
<OFF> TO CLEAR
OK
I
Z22 FUNCTION
(alternating)
LIVING ROOM
You may now click and then select any
other item on the USER SETTINGS menu, or click
to quit programming. When <OK> TO EXIT
appears - click
OK
I
.
Reviewing the Bypassed Zone List
Having entered your user code successfully (see above -
Entering to the User Settings Menu), the display will read:
PRESS
RESULTANT DISPLAY
SET BYPASS
Enter user code
SHOW BYPASS
OK
I
BYPASS LIST
If at this point you click
OK
I
, the number, state and
name of the first bypassed zone will be displayed.
You can now click
repeatedly to review all
bypassed zones, in ascending numerical order. When
done, clicking
will get you back to SHOW
BYPASS and clicking
will get you back to
<OK> TO EXIT.
Recalling the Last Bypass Scheme
Arming the alarm system with several zones in the
bypassed state is in fact "partial arming". An
identical partial arming may be repeated by recalling
the last bypassing scheme (that was suspended and
memorized upon disarming the system).
Having entered your user code
successfully (see
above - Entering to the User Settings Menu), the
display will read:
To Next Page
Loading...
