vitapur VWD366BLP - Operation

Max.
Min.
TEMP
COLD WATER
Min Max
Operation
1. DISPENSING COLD WATER
3. REPLACING THE WATER BOTTLE
2. DISPENSING HOT WATER
3
4
1 2
5
6
7
1
2
1 2
6 7
1 3 4 5
14 Min
8
2
4. ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
NOTICE: This model Water Dispenser left the factory with the cold
water temperature control factory “default setting” positioned for
“Energy Star” compliance (identied to the side). This setting will
deliver cold water temperatures between 8°C ~ 10°C (46.4°F ~
50°F) The cold water temperature can be adjusted, (using a at
screwdriver) by rotating the adjustment screw clockwise or anti-
clockwise between “Min” (cool) and “Max” (colder) until the desired
temperature is reached. NOTE: Any change/adjustment to the cold
water temperature control may effect Energy Star efciency. If the
water dispenser is not dispensing water, there could be a possible
ice build-up due to the cold water temperature control being set too
cold. If this happens, unplug the dispenser overnight and then reset.
Set thermostat to high, slowly increasing based on your use and
need for cold water.
ENERGY STAR FACTORY
DEFAULT SETTING