4
• The unit is not intended for usage by
physically or mentally disabled per-
sons (including children) or by per-
sons lacking experience or knowledge
if they are not under supervision of
a person who is responsible for their
safety or if they are not instructed by
this person on the usage of the unit.
• Close supervision is necessary when
children or disabled persons are near
the operating unit.
• For children safety reasons do not
leave polyethylene bags used as a
packaging unattended.
Attention! Do not allow children to play
with polyethylene bags or packaging film.
Danger of suffocation!
• Do not attempt to repair the unit. Do
not disassemble the unit by yourself,
if any malfunction is detected or after
it was dropped, unplug the unit and
apply to any authorized service center
at the contact addresses given in the
warranty certificate and on the website
www.vitek.ru.
• Transport the unit in the original pack-
age only.
• Keep the unit out of reach of children
and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USE ONLY, ITS COMMERCIAL USAGE
AND USAGE IN PRODUCTION AREAS AND
WORK SPACES IS PROHIBITED.
USING THE HAIR CLIPPER
In case of the unit transportation or
storage at low temperature keep it for at
least three hours at room temperature.
– Remove any packaging elements that
can prevent the unit operation.
Blades
– If the blades have been removed for
cleaning or replacement, install them
back, adjust and tighten the fastening
screws (pic. 1).
Blade shifter (2) (pic. 2)
– When you cut hair without using
attachments (5, 6, 7, 8), you can shift
the blade to adjust the cutting length.
– In the upper shifter (2) position, haircut
will be the shortest.
– In the lower shifter (2) position, the
cutting length is approximately the
same as when using 3 mm attachment
comb (5).
– By changing the position of the shifter
(2) while cutting hair, you can select
the necessary cutting length.
– If hair is jammed in the blades while
cutting, move the shifter (2) from the
upper position to the lower position
several times, this will help to release
the jammed hair without removing the
blades.
– When the hair clipper is switched on,
move the shifter (2) several times
from the upper position to the lower
position, this way you can remove the
cut-off hair from the blades.
– If the hair clipper pulls hair while cut-
ting, it means that the blades became
blunt, replace them with new ones.
Lubricating oil
– To maintain the unit in a good condi-
tion, you should lubricate the blades
periodically. Do not use vegetable oil
or oil that includes solvents. Solvents
are subjected to evaporation, and the
remaining thick oil can slow down the
upper blade moving speed.
– For lubricating the blades use the
oil (11) supplied with the unit.
HAIR STYLING INSTRUCTIONS
• Hair should be clean and dry during
hair cutting.
• Insert the power plug into the mains
socket.
• Before cutting hair switch the hair clip-
per on, moving the power switch (4)
to the position «I» and make sure that
IM VT-2580.indd 4 22.01.2018 16:37:42
To Next Page
Loading...
