6
• You can use the comb: lift the hair
locks and cut them with the hair clipper
above the comb (9) (pic. 8).
• Always start cutting from the head
back.
• Comb (9) the hair to reveal uneven
locks.
• Use scissors (10) to trim hair.
Step 5 – the final part
– In the final stage of hair cutting
remove the attachment comb from
the unit, turn the blades of the clipper
towards the hair and trim hair on the
temples and neck carefully. Do not
press the clipper strongly, there is
danger of injuries or cuts when open
blades come in contact with skin
(pic. 9).
Cone-shaped haircut
Set the necessary attachment comb and
start cutting from the head back towards
the crown. Cut hair against hair growth
from the head front to the crown and from
the sides (pic. 10). To get a flat top haircut,
use the comb: lift the locks and cut them
along the comb. Comb the hair to reveal
uneven locks.
After you finish cutting hair, switch the hair
clipper off setting the power switch (4) to
the position «O» and take the power plug
out of the socket, put the protective cover
(1) on the blades.
CLEANING AND CARE
Lubricating the blades
Regularly lubricate the blades using the oil
(11) supplied with the unit.
– Switch the unit off using the power
switch (4) and unplug it.
– Apply one-two drops of oil (11) on the
teeth of the blades and the back side
of the upper blade, switch the unit
on and make sure that the blades are
moving smoothly.
– Switch the unit off, clean the excess oil
with a dry cloth.
Attention! Use only the oil supplied with
the unit.
DO NOT USE vegetable oil, fat, oil mixed
with any solvents for lubricating.
Solvents will evaporate, leaving thick
grease that may slow down the blades’
motion.
Cleaning the hair clipper
– Switch the hair clipper off and unplug it.
– Clean the blades from hair, using the
cleaning brush (12).
– Wipe the accessories and the unit
body (3) with a slightly wet cloth, and
then dry them with a soft cloth.
– Put the protective cover (1) on the
blades.
– Do not immerse the unit into water or
other liquids.
– Do not use solvents or abrasives for
cleaning the hair clipper body.
STORAGE
– Before taking the hair clipper away for
storage clean and lubricate the blades
with lubricating oil (11) and put the pro-
tective cover (1) on.
– Keep the hair clipper in a dry cool
place out of reach of children and dis-
abled persons.
DELIVERY SET
Hair clipper (with blades) – 1 pc.
Attachment comb – 4 pc.
Protection lid – 1 pc.
Lubricating oil – 1 pc.
Cleaning brush – 1 pc.
Comb – 1 pc.
Scissors – 1 pc.
Instruction manual – 1 pc.
TECHNICAL SPECIFICATIONS
Nominal voltage: 220-240 V, ~ 50 Hz
Rated input power: 7 W
IM VT-2580.indd 6 22.01.2018 16:37:42
To Next Page
Loading...
