Vitek VT-2580 - Safety Measures

ENGLISH
3
HAIR CLIPPER VT-2580
This set is intended for cutting hair and
styling.
DESCRIPTION
1. Blades protective cover
2. Blade shifter
3. Body
4. Power switch «0/I»
5. 3 mm attachment comb
6. 6 mm attachment comb
7. 9 mm attachment comb
8. 12 mm attachment comb
9. Comb
10. Scissors
11. Lubricating oil
12. Cleaning brush
ATTENTION!
– After using the hair clipper in a bath-
room, disconnect the power plug from
the mains socket, as water close-
ness is dangerous even if the unit is
switched off.
– For additional protection you can
install a residual current device (RCD)
with nominal operation current not
exceeding 30 mA into the bathroom
mains; contact a specialist for instal-
lation.
SAFETY MEASURES
Read this instruction manual carefully
before using the unit and keep it for future
reference for the whole unit operation
period. Use the unit for intended pur-
poses only, as specified in this manual.
Mishandling of the unit may lead to its
breakage and cause harm to the user or
damage to his/her property.
• Before using the unit for the first time,
make sure that the voltage in your
mains corresponds to unit operating
voltage.
• The power cord may not:
– touch hot objects and surfaces,
– be immersed into water,
– run over sharp edges of furniture,
– be used as a handle for carrying
the unit.
• Use the unit to cut only natural human
hair, hair should be dry.
• Do not use the unit to cut artificial hair
and animal hair.
• Use only the attachments supplied.
ATTENTION! Do not immerse the hair
clipper, the power cord and the plug into
water or any other liquids. Do not wash the
clipper blades under water jet.
• Do not touch the hair clipper body and
the power cord with wet hands.
• Do not use the unit in places with
high temperature and relative humidity
more than 80%.
• Do not keep the unit near a bath or a
sink filled with water.
• If the unit is dropped into water,
unplug it immediately, and only then
take it out of the water.
• Do not use the unit outdoors.
• Never use the unit if the attachment
combs are broken or damaged or if
the blades are damaged.
• After each use clean the attachments
and the blades with the brush to
remove the cut-off hair.
• Make sure that the blades are clean
and that there is lubricating oil on them.
• Never leave the operating unit unat-
tended.
• Switch the hair clipper off during inter-
vals in operation or when you are not
using it.
• Do not allow children to use the unit
as a toy.
• Do not allow children to touch the hair
clipper body and the power cord dur-
ing the unit operation.
• During the unit operation and breaks
between operation cycles, place the
unit out of reach of children and dis-
abled persons.
• This unit is not intended for usage by
children.
IM VT-2580.indd 3 22.01.2018 16:37:42